Case after drilling holes for the hard drive and case fan.

Hard drive and case fan are installed and fit perfectly.

Holes drilled for the front motherboard and for the power supply. Also dremmeled the front ports for the motherboard and power supply. Using rubber washers as standoffs and using a simple screw/nut system for securing.

Holes are drilled for power supply and motherboard (bottom view). Tape was used to temporarily secure the screws while the parts were being put in.

Motherboard installed and fitment is good. Nuts secured tight and motherboard is not touch case on the bottom.

Screws, rubber washers, and plastic washers are installed for the power supply. Foam is added to give the gel-pad for the power supply a tighter grip.

Gel-pad from the power supply is put over the foam.

Power supply is installed and secured with nuts. There is absolutely NO room between the motherboard and power supply, they are touching.

Power and IDE cables are installed and put into place. The box is now ready.