M3-ATX PicoPSU Form-Factor 125W Intelligent Wide Input 6-24V Vehicle/Battery DC-DC Power Supply

M3-ATX Intelligent Vehicle DC-DC Power Supply
£45.00 
  £54.00 inc. VAT
  IN STOCK (Checked 23:59 BST)

You may also require

Short Molex to P4 Power Cable (*see note)
£3.50 
  £4.20 inc. VAT
  IN STOCK (Checked 23:59 BST)

M3-ATX Serial Cable Harness (Type 1))
£4.50 
  £5.40 inc. VAT
  IN STOCK (Checked 23:59 BST)

AC/DC Barrel Connector Cable (useful for testing with one of our AC Adapters)
£3.50 
  £4.20 inc. VAT
  IN STOCK (Checked 23:59 BST)
 

Designed to provide power and to control the ON/OFF switch of a motherboard (PC) based on ignition status, M3-ATX is a wide input (6-24V) vehicle or general purpose battery powered application DC-DC ATX power supply capable of surviving tough car engine cranks (down to 6V) as well as transient over-voltage situations.

The M3-ATX is based on an electrically similar design to the M2-ATX but with dramatic size reductions (picoPSU plug-in style).

  • 125 Watts (150watt peak) PSU
  • 20pin ATX, 6-24V wide input range
  • Programmable timing settings using optional serial harness and utility
  • Intelligent shutdown controller
  • ON/OFF motherboard control
  • Survives vehicle engine cranks
  • Battery deep discharge prevention
  • High efficiency, 125 watts output
  • "Anti-Thump" Amplifier remote control
  • < 0.5mA standby current
  • Solid Japanese Polymer capacitors

M3-ATX comes equipped with a ATX, Molex HDD, SATA HDD and Floppy cable harness, jumpers, faston connectors and cables for Thump and Motherboard ON/OFF switch. Just connect to your 12V or 24V car/boat/RV battery and power up your PC.

Programmable shutdown / sleep modes via optional serial cable; Fits any motherboard equipped with a 20 or 24pin ATX connector; 100% silent, fanless, no moving parts; Operates from 6-24V; Multi-chemistry batteries supported; Highly efficient design - does not produce a lot of heat; Ideal for low power Intel Core processors as well as all Atom, VIA or AMD processors.

*Note: If your board has a 4 pin 12V P4 power connector, you will need add a Molex to 12V P4 Power Cable. Not compatible with Zotac NM10-E board due to positioning of P4 connector on board.

M3-ATX Manual

M3-ATX Timing Settings

Don't see what you want here? Send us an email with as much information as possible, and we'll try and get it for you.

Reckoner

Search tools:
Board Finder
Case Finder
Mini PC Finder

Cards accepted:
Secure Shopping: